Is There A Way To Have A Motion Sensor Be Less Sensitive?

1. Get a step ladder or a chair so that you can get up to eye level with your motion detector to get a closer look at it. You are looking for a small adjustment screw on the motion detector that adjusts its sensitivity.

2. You can turn the screw one of two ways. Most of them will usually have a plus and a minus sign indicating which way to make the motion sensor more sensitive or less sensitive.

3. Tell ADT you will be testing your alarm. Since ADT will get calls if your alarm goes off, you want to avoid that confusion.

4. Adjust the motion sensor towards the minus sign to be less sensitive and then set your alarm. Now, try walking through the area to see if the alarm goes off. You always want it to go off if a person is trying to go through your house when they should not be. If this works ok, then try to get your pet to go into the path of the motion detector beam.

5. Another important note is take notice of how you have your motion detector pointed. Where will it's path of motion generally be? Some motion detectors you can point down toward the ground a bit more. If they are pointed towards the ground, then they will pick up your pet's motion. If the pet sets off the motion detector, then readjust and try it again until you get it right.

6. Another option is to take a small piece of masking tape and put it over the lower part of the motion detector unit. This is to cut off part of the beam. Imagine that the beam is coming out of the system in a large swath from floor to ceiling. What the pet immue motion detectors do is cut off the lower part of the beam so that it is just tracking movement up high. This will work as long as your pets don't still jump up and get in front of the beam. Cats are known to do this.

Thanks