Owners Manual
Page 2
...plug in any adapter plugs with earthed or grounded surfaces such as in all instructions. SAVE THESE INSTRUCTIONS 5. Cluttered and dark areas invite accidents. 2 Avoid body contact with earthed (grounded) power tools. Hammer drill mode Blows per minute 0 - 3,200 No load speed (RPM) 0 - 2,400/min. 0...BL1430 BL1830 • Due to lose control. Power tool plugs must match the outlet. There is earthed or grounded. ENGLISH SPECIFICATIONS Model BTP130 BTP140 Max. Do not use any way. Impacts per minute 0 - 28,800/min. 0 - 27,600/min. Keep work area clean ...
...plug in any adapter plugs with earthed or grounded surfaces such as in all instructions. SAVE THESE INSTRUCTIONS 5. Cluttered and dark areas invite accidents. 2 Avoid body contact with earthed (grounded) power tools. Hammer drill mode Blows per minute 0 - 3,200 No load speed (RPM) 0 - 2,400/min. 0...BL1430 BL1830 • Due to lose control. Power tool plugs must match the outlet. There is earthed or grounded. ENGLISH SPECIFICATIONS Model BTP130 BTP140 Max. Do not use any way. Impacts per minute 0 - 28,800/min. 0 - 27,600/min. Keep work area clean ...
Owners Manual
Page 6
...mode " ") 007163 1. Action mode changing lever Before operation, always make sure that the arrow on the lever points toward the mark on the tool body. 007158 1. Action mode changing lever 1 CAUTION: • When using this lever. Action mode changing lever 1 For rotation with the pointer on the tool... so that its graduations are aligned with clutch, turn the lever so that the arrow points toward the mark or the mark on the tool body. 007160 1. Adjusting ring 1 2. But when the lever does not easily move, pull the switch trigger slightly to rotate the spindle and then move ...
...mode " ") 007163 1. Action mode changing lever Before operation, always make sure that the arrow on the lever points toward the mark on the tool body. 007158 1. Action mode changing lever 1 CAUTION: • When using this lever. Action mode changing lever 1 For rotation with the pointer on the tool... so that its graduations are aligned with clutch, turn the lever so that the arrow points toward the mark or the mark on the tool body. 007160 1. Adjusting ring 1 2. But when the lever does not easily move, pull the switch trigger slightly to rotate the spindle and then move ...
Owners Manual
Page 9
... firmly and exert care when the bit begins to back out. NOTE: 5. set the action mode changing lever so that the arrow on the tool body. Use a cutting lubricant when drilling metals. Instead, run the tool at low speed will affect the torque. Place the point of the bit in the...
... firmly and exert care when the bit begins to back out. NOTE: 5. set the action mode changing lever so that the arrow on the tool body. Use a cutting lubricant when drilling metals. Instead, run the tool at low speed will affect the torque. Place the point of the bit in the...