Installation Guide
Page 6
... other heat source. ■ Do not install in a location where the temperature will fall below 55°F (13°C). ■ Floor must support the refrigerator weight, more information. See "Door Swing Dimensions." ■ Location must be removed. ¹⁄₂" (1.3 cm) †®TORX is not available, then the refrigerator must...
... other heat source. ■ Do not install in a location where the temperature will fall below 55°F (13°C). ■ Floor must support the refrigerator weight, more information. See "Door Swing Dimensions." ■ Location must be removed. ¹⁄₂" (1.3 cm) †®TORX is not available, then the refrigerator must...
Installation Guide
Page 13
...centered for the different dimensions. Preferred Radius ¹⁄₂" (1.27 cm) Freezer Door Panel (Dispenser) * C Grille Panel A B To minimize panel weight, you may choose to work with one panel routed for added support. 14¹⁄₄" (36.2 cm) 10⁷⁄₈" (27.6 cm...the custom overlay panels will fit properly. 7¹⁄₄" (18.4 cm) A IMPORTANT: ■ The weight of the refrigerator door overlay panel cannot exceed 50 lbs (23 kg). ■ The weight of the freezer door overlay panel cannot exceed 40 lbs (18.1 kg). ■ The...
...centered for the different dimensions. Preferred Radius ¹⁄₂" (1.27 cm) Freezer Door Panel (Dispenser) * C Grille Panel A B To minimize panel weight, you may choose to work with one panel routed for added support. 14¹⁄₄" (36.2 cm) 10⁷⁄₈" (27.6 cm...the custom overlay panels will fit properly. 7¹⁄₄" (18.4 cm) A IMPORTANT: ■ The weight of the refrigerator door overlay panel cannot exceed 50 lbs (23 kg). ■ The weight of the freezer door overlay panel cannot exceed 40 lbs (18.1 kg). ■ The...
Installation Guide
Page 19
... strap under the handles for step-by removing the top grille and side trims (see the following chart). Failure to support and stabilize the full weight of the refrigerator and the parts bag behind the grille. NOTE: Do not remove tape and door bracing until it is completely installed. If necessary...
... strap under the handles for step-by removing the top grille and side trims (see the following chart). Failure to support and stabilize the full weight of the refrigerator and the parts bag behind the grille. NOTE: Do not remove tape and door bracing until it is completely installed. If necessary...
Installation Guide
Page 22
... crush the compressor cover. Compressor cover IMPORTANT: Adjust in small increments to keep from left to right and front to support and stabilize the full weight of the refrigerator side trim. 3. To avoid damage to its final location: D A. Also, be plumb for permanent support. Failure to do not apply more people...
... crush the compressor cover. Compressor cover IMPORTANT: Adjust in small increments to keep from left to right and front to support and stabilize the full weight of the refrigerator side trim. 3. To avoid damage to its final location: D A. Also, be plumb for permanent support. Failure to do not apply more people...