Specifications
Page 45
... will stay within specification limits if the drive is used to run vertically and vice versa. The jumper setting method is 3.0±0.5 kgf-cm. Performance and error rate will stay within the specified error rates when tilted ±5degrees from which it was formatted. Travelstar 5K100 Hard Disk Drive Specification 31 6.4.2 Mounting hole locations The mounting...
... will stay within specification limits if the drive is used to run vertically and vice versa. The jumper setting method is 3.0±0.5 kgf-cm. Performance and error rate will stay within the specified error rates when tilted ±5degrees from which it was formatted. Travelstar 5K100 Hard Disk Drive Specification 31 6.4.2 Mounting hole locations The mounting...
Specifications
Page 69
... spin up at shipment is a Master. Two addresses require the setting of the AT interface cable. If pin 28 is ground (or low), the drive is Setting 1 (no jumper). When the drive address is Cable Select, the address depends on the interface connector determines the drive address. Travelstar 5K100 Hard Disk Drive Specification 55 Three drive addresses are shown below.
... spin up at shipment is a Master. Two addresses require the setting of the AT interface cable. If pin 28 is ground (or low), the drive is Setting 1 (no jumper). When the drive address is Cable Select, the address depends on the interface connector determines the drive address. Travelstar 5K100 Hard Disk Drive Specification 55 Three drive addresses are shown below.
Specifications
Page 131
on page 119. Travelstar 5K100 Hard Disk Drive Specification 117 Table 76: Identify device information. (Part 6 of cylinders/heads/sectors by Set Features Command (01h to 0 7(=0) Reserved 6(=X) 1=Semi-duplex mode is enabled 5(=X) 1=Device 0 detected Device 1 4(=X) 1=Device 1 passed diagnostic 3(=X) 1=Device 0 passed diagnostic 2-1(=X) how Device 0 determined the device number: 00=Reserved 01=a jumper was used 10=the CSEL...
on page 119. Travelstar 5K100 Hard Disk Drive Specification 117 Table 76: Identify device information. (Part 6 of cylinders/heads/sectors by Set Features Command (01h to 0 7(=0) Reserved 6(=X) 1=Semi-duplex mode is enabled 5(=X) 1=Device 0 detected Device 1 4(=X) 1=Device 1 passed diagnostic 3(=X) 1=Device 0 passed diagnostic 2-1(=X) how Device 0 determined the device number: 00=Reserved 01=a jumper was used 10=the CSEL...