Planning Guides
Page 1
... further information. • This appliance must be installed in accordance with an appliance cord. ELECTRICAL ACCESS DIMENSIONS Model A B C D E* ER36D 5 5/8" (142.9 mm) 18 3/8" (466.7 mm) 10 3/4" (273.0 mm) 13 11/16" (347.7 mm) 7/8" (22.2 mm) ER48D 3 13/16" (96.8 mm) 18 11/16" 9 3/8" 13 3/4" 1 1/8" (474.7... 5" Water Column 6" Water Column Propane (LP) 10" Water Column 11" Water Column * Maximum gas supply pressure 1/2 p.s.i. www.Dacor.com Phone: (800) 793-0093 5.10 Gas regulator access, cover removed Range electrical access, cover removed Inlet B A C Back of...
... further information. • This appliance must be installed in accordance with an appliance cord. ELECTRICAL ACCESS DIMENSIONS Model A B C D E* ER36D 5 5/8" (142.9 mm) 18 3/8" (466.7 mm) 10 3/4" (273.0 mm) 13 11/16" (347.7 mm) 7/8" (22.2 mm) ER48D 3 13/16" (96.8 mm) 18 11/16" 9 3/8" 13 3/4" 1 1/8" (474.7... 5" Water Column 6" Water Column Propane (LP) 10" Water Column 11" Water Column * Maximum gas supply pressure 1/2 p.s.i. www.Dacor.com Phone: (800) 793-0093 5.10 Gas regulator access, cover removed Range electrical access, cover removed Inlet B A C Back of...
Planning Guides
Page 2
Range Model ER36D ER48D CUT-OUT DIMENSIONS F G 42" (1067 mm)* 36" (914 mm)** 36 1/16" (916 mm)** 54" (1372 mm)* 48" (1219 mm)** 48 1/16" (1221 mm... range when it is at discretion of customer but cabinet face MUST NOT protrude further than rear of front panel, see product dimensions. 3 Consult local code for exact location requirements. 4 Not applicable for minimum required clearances. 2 Cabinet/countertop depth is installed.... control panel Countertop height: 30 1/4" (768 mm) Min. 36 1/2" (927 mm) Max. Raised vent installation side view www.Dacor.com Phone: (800) 793-0093 5.11
Range Model ER36D ER48D CUT-OUT DIMENSIONS F G 42" (1067 mm)* 36" (914 mm)** 36 1/16" (916 mm)** 54" (1372 mm)* 48" (1219 mm)** 48 1/16" (1221 mm... range when it is at discretion of customer but cabinet face MUST NOT protrude further than rear of front panel, see product dimensions. 3 Consult local code for exact location requirements. 4 Not applicable for minimum required clearances. 2 Cabinet/countertop depth is installed.... control panel Countertop height: 30 1/4" (768 mm) Min. 36 1/2" (927 mm) Max. Raised vent installation side view www.Dacor.com Phone: (800) 793-0093 5.11
Planning Guides
Page 1
...Install all governing codes and ordinances during planning and installation. The maximum installed height must be installed in accordance with a single Dacor approved remote or in raised position 10" (254 mm) warning • Observe all appliances according to 120 Vac, 60 ...must not exceed the maximum specified countertop height of unit Product data label 28" 3 prong grounded power cord Dimensions Side View Adjustable anchor legs Dimensions Front View Model No. grounded, dedicated, circuit * Includes power supply requirements for proper applications and cutout ...
...Install all governing codes and ordinances during planning and installation. The maximum installed height must be installed in accordance with a single Dacor approved remote or in raised position 10" (254 mm) warning • Observe all appliances according to 120 Vac, 60 ...must not exceed the maximum specified countertop height of unit Product data label 28" 3 prong grounded power cord Dimensions Side View Adjustable anchor legs Dimensions Front View Model No. grounded, dedicated, circuit * Includes power supply requirements for proper applications and cutout ...
Planning Guides
Page 3
... of chassis On 30" and 36" wide models, the vertical center line of bottom knock- Install all appliances according to change without notice. www.Dacor.com Phone: (800) 793-0093 8.3 out is offset 3" Side Exhaust Knock Outs (1 5/8" X 16") 5" (127 mm) 2" X 16", connects ... vent 1" (25 mm) 3 1/4" X 10" to duct work ADT2 transition (included) NOTE: See the appliance planning guide page for cutout dimensions Front of unit Blower wiring access hole in side Blower wiring access hole in bottom Wiring/conduit connections for rEmote/in-line blower Specifications subject...
... of chassis On 30" and 36" wide models, the vertical center line of bottom knock- Install all appliances according to change without notice. www.Dacor.com Phone: (800) 793-0093 8.3 out is offset 3" Side Exhaust Knock Outs (1 5/8" X 16") 5" (127 mm) 2" X 16", connects ... vent 1" (25 mm) 3 1/4" X 10" to duct work ADT2 transition (included) NOTE: See the appliance planning guide page for cutout dimensions Front of unit Blower wiring access hole in side Blower wiring access hole in bottom Wiring/conduit connections for rEmote/in-line blower Specifications subject...
Installation Instructions
Page 2
No liability is assumed by Dacor® for future reference and the local building inspector's use. Leave these installation instructions with the customer. • ...minimize problems, read these installation instructions for changes in specifications. © 2007 Dacor, all rights reserved. Table of Contents Important Safety Instructions 1-3 Customer Service Information 3 Planning the Installation 4-6 Electrical Requirements 4 Gas Supply Requirements 4 Product Dimensions 5 Cabinet Layout 6 Installation Instructions 7-18 Preparing for Installation 7-9 Electrical Connection ...
No liability is assumed by Dacor® for future reference and the local building inspector's use. Leave these installation instructions with the customer. • ...minimize problems, read these installation instructions for changes in specifications. © 2007 Dacor, all rights reserved. Table of Contents Important Safety Instructions 1-3 Customer Service Information 3 Planning the Installation 4-6 Electrical Requirements 4 Gas Supply Requirements 4 Product Dimensions 5 Cabinet Layout 6 Installation Instructions 7-18 Preparing for Installation 7-9 Electrical Connection ...
Installation Instructions
Page 7
Planning the Installation Product Dimensions Product tolerances: ±1/16" (±1.6 mm) GAS - Canadian units come from top of trim (76 mm) ** Finished side panel (940 mm) (908 mm) ** Optional Width: ER36D - 35 7/8" (911 mm) ER48D - 47 7/8" (1216 mm) 5 Gas regulator access... (1 3/8" for use in Canada is ¼" (6.4mm) larger Inlet than those stated. ELECTRICAL ACCESS DIMENSIONS Model A B C D E* ER36D 5 5/8" (142.9 mm) 18 3/8" (466.7 mm) 10 3/4" (273.0 mm) 13 11/16" (347.7 mm) 7/8" (22.2 mm) ER48D 3 13/16" (96.8 mm) 18 11/16" 9 3/8" 13 3/4" 1 1/8" (474.7 mm...
Planning the Installation Product Dimensions Product tolerances: ±1/16" (±1.6 mm) GAS - Canadian units come from top of trim (76 mm) ** Finished side panel (940 mm) (908 mm) ** Optional Width: ER36D - 35 7/8" (911 mm) ER48D - 47 7/8" (1216 mm) 5 Gas regulator access... (1 3/8" for use in Canada is ¼" (6.4mm) larger Inlet than those stated. ELECTRICAL ACCESS DIMENSIONS Model A B C D E* ER36D 5 5/8" (142.9 mm) 18 3/8" (466.7 mm) 10 3/4" (273.0 mm) 13 11/16" (347.7 mm) 7/8" (22.2 mm) ER48D 3 13/16" (96.8 mm) 18 11/16" 9 3/8" 13 3/4" 1 1/8" (474.7 mm...
Installation Instructions
Page 8
...the purpose of personal injury and to combustible surface from the edge of utilities 3 10" (254 mm) Min. CUTOUT DIMENSIONS Range Model F G ER36D 42" (1067 mm)* 36 1/16" 36" (914 mm)** (916 mm)** ER48D 54" (1372 mm)* 48 1/16" 48" (1219 mm)** (1221 mm)** * Recommended ** Minimum H 33 ... do not interfere with Range Hood F Gas and Electrical Service • The shaded area shown denotes the location of the range. Dacor strongly recommends installing a non-combustible material on or shutting off valve when the unit is the recommended location. The installation must allow...
...the purpose of personal injury and to combustible surface from the edge of utilities 3 10" (254 mm) Min. CUTOUT DIMENSIONS Range Model F G ER36D 42" (1067 mm)* 36 1/16" 36" (914 mm)** (916 mm)** ER48D 54" (1372 mm)* 48 1/16" 48" (1219 mm)** (1221 mm)** * Recommended ** Minimum H 33 ... do not interfere with Range Hood F Gas and Electrical Service • The shaded area shown denotes the location of the range. Dacor strongly recommends installing a non-combustible material on or shutting off valve when the unit is the recommended location. The installation must allow...
Installation Instructions
Page 9
If any item is 1/16" (2 mm) off the floor. Parts List • 3 Grates • 3 18" Racks (ER48D only) • 2 Small stack burner caps • 6 Knobs • 2 Small stack burner rings • Anti-tip bracket w/screws • 2 Large stack burner caps ... a licensed electrician. • Before installing the range, you must report cosmetic issues within 30 days of range Range right side panel ANTI-TIP BRACKET PLACEMENT Dimension ER36D ER48D J 7 1/2" (191 mm) 19" (483 mm) K 6 1/2" (165 mm) 6 1/4" (159 mm) 7 Do not install a damaged or incomplete appliance. Readjust ...
If any item is 1/16" (2 mm) off the floor. Parts List • 3 Grates • 3 18" Racks (ER48D only) • 2 Small stack burner caps • 6 Knobs • 2 Small stack burner rings • Anti-tip bracket w/screws • 2 Large stack burner caps ... a licensed electrician. • Before installing the range, you must report cosmetic issues within 30 days of range Range right side panel ANTI-TIP BRACKET PLACEMENT Dimension ER36D ER48D J 7 1/2" (191 mm) 19" (483 mm) K 6 1/2" (165 mm) 6 1/4" (159 mm) 7 Do not install a damaged or incomplete appliance. Readjust ...