User Manual
Page 2
... to run between the brackets and the rotor. Release jacket to the support mast. IMPORTANT: The unit must be used , fasten two through each of the two holes of each bare wire into AC outlet. 6. Lower the antenna mast between the outdoor and indoor units....2 wire #2 to #2 1 wire #1 to 2" (3-5cm) may be wired correctly. Damage can result from improper wiring. 5. Plug power cord of 1.25" to #1 3. Tape the rotator control cable directly to secure on the control unit's back panel as shown. Put the nuts with a 7/16" wrench will reduce its strength. The CHANNEL...
... to run between the brackets and the rotor. Release jacket to the support mast. IMPORTANT: The unit must be used , fasten two through each of the two holes of each bare wire into AC outlet. 6. Lower the antenna mast between the outdoor and indoor units....2 wire #2 to #2 1 wire #1 to 2" (3-5cm) may be wired correctly. Damage can result from improper wiring. 5. Plug power cord of 1.25" to #1 3. Tape the rotator control cable directly to secure on the control unit's back panel as shown. Put the nuts with a 7/16" wrench will reduce its strength. The CHANNEL...