Question posted by bobrgi1 on November 10th, 2023
Stuck On Calibration Page
Current Answers
Answer #1: Posted by Technoprince123 on November 11th, 2023 3:07 AM
Please response if this answer is acceptable and solw your problem thanks
Answer #2: Posted by SonuKumar on November 11th, 2023 10:32 PM
Unplug the speaker from the power outlet and wait for 30 seconds. This will allow the speaker to reset.
Plug the speaker back into the power outlet and turn it on. The speaker should now go through the calibration process and start playing music.
If the speaker is still stuck on the calibration page, try updating the firmware. You can find the latest firmware on the Pyle website.
If you have tried all of the above and the speaker is still stuck on the calibration page, you may need to contact Pyle customer support.
Here are some additional tips:
Make sure that the speaker is not connected to any other devices.
Make sure that the speaker is not muted.
Try turning the speaker up or down in volume.
Try using a different power outlet.
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Similar Questions
I need the calibration instructions for my Pyle PSPL25 sound level meter.
My new Pyle PS900 voltage meter needs calibrated. It reads 169 volts on a 120 volt system.
volume will not go up or down it only changes when you turn it to zero. its stuck on a low volume.
The screen on our plts76du can't move,it's stuck between open and close. How can I close it?