All My Indicators On My Controller Are Blinking At The Same Time And Won't Sto

• Normally caused by voltage drop, some reasons
• Wrong voltage from a wall mount transformer (needs to be 14V if longer than 50ft)
• Non pool transformer that does not support 14V
• Cord run from the transformer to the ultimate light too long
• Single low gauge run to multiple lights from the transformer to the JBox
• Low utility input voltage
• Too many lights (more than 3) are installed on the transformer

• Usually an indication that a junction box transformer that is operating in White or a Color Show in ambient outdoor temps north of 95 degrees at night.

If all the indicators on your Hayward ColorLogic light controller are blinking at the same time and won't stop, it is likely that there is a problem with the controller itself. Here are a few things you can try to fix the problem:

Check the power supply. Make sure that the controller is properly plugged in and that the power is turned on.

Reset the controller. Press and hold the reset button on the controller for 10 seconds. This will clear all the settings on the controller and return it to factory defaults.

Replace the controller. If resetting the controller does not fix the problem, you may need to replace the controller itself.

Here are the steps on how to reset your Hayward ColorLogic light controller:

Locate the reset button on the controller. It is a small, recessed button on the front of the controller.

Use a paperclip or other small object to press and hold the reset button for 10 seconds.

The controller will reset and all the indicators will turn off.

Once the controller has reset, you can release the reset button.

If you have tried all of the above and you are still having problems with your Hayward ColorLogic light controller, you may need to contact Hayward customer service for assistance. They can be reached at 1-800-248-2323.

Thanks

Check the power supply. Make sure that the controller is properly plugged in and that the power is turned on.

Reset the controller. Press and hold the reset button on the controller for 10 seconds. This will clear all the settings on the controller and return it to factory defaults.

Replace the controller. If resetting the controller does not fix the problem, you may need to replace the controller itself.

Here are the steps on how to reset your Hayward ColorLogic light controller:

Locate the reset button on the controller. It is a small, recessed button on the front of the controller.

Use a paperclip or other small object to press and hold the reset button for 10 seconds.

The controller will reset and all the indicators will turn off.

Once the controller has reset, you can release the reset button.

If you have tried all of the above and you are still having problems with your Hayward ColorLogic light controller, you may need to contact Hayward customer service for assistance. They can be reached at 1-800-248-2323.